For lovers of WWI aircraft

[jknaus]

Aviattic has finally released their bare frame work for the WNW Fokker DVII. Its 3D printed from Shapeways and you can mate the forward frame from the kit to a tail and or top and bottom wings etc and show off all the glorious interior detail. See it here.

Also at Shapeways my friend Bo has just released a 1/32 Fokker D.III here.

You will need to get an engine and this kit is designed for Taurus Models Oberursel U.III engine.

And a paint scheme.

James

 

[moon puppy]

Oh MAN! That's sharp. Thanks for the heads up James.

Hey, get your buddy Bo to make the pulley for the Eindecker, and Control Horns!!

 

[Swordsman]

Nice ... Thanks for sharing James ... :salute

 

[lupanzer]

Fantastic stuff!...

Luiz.

 

[Heavens Eagle]

As usual you are our info guy on anything WW1 James!

That engine looks awesome and the D.III is very tempting. I bet it ends up being a pretty penny though as high res 3D printouts.

 

[jknaus]

lol.
It is a bit pricey but its the only game in town and for someone wanting to go all out it will be quite the model. I'm wobbling on it although I know I shouldn't.

 

[Sherman 18]

I think we are looking at the future of scale modeling.

 

[phantom II]

Aviattic has finally released their bare frame work for the WNW Fokker DVII. Its 3D printed from Shapeways and you can mate the forward frame from the kit to a tail and or top and bottom wings etc and show off all the glorious interior detail. See it here.

Also at Shapeways my friend Bo has just released a 1/32 Fokker D.III here.

You will need to get an engine and this kit is designed for Taurus Models Oberursel U.III engine.

And a paint scheme.

James

That is one beauty of an engine but why stop before you install the ignition wires :idonno

Cheers, Christian B)